Step 11
Put back the lithium battery into the body.
( which will cause it to operate )
The Red indication light will come on after 5 seconds.
This means the lubricator has been started normally.

* If the Red indication light flashes rapidly, then the battery was installed incorrectly, the battery needs to be taken out and put in again slowly and steadily.

Step 12
Put the cover back on and write down the following information: the lubrication period setting, date of installation and the type of grease.
*The Information on the cover must be updated each time the grease cup is changed or the dip switch settings are changed.

Step 13
Make sure that the press plate is in the correct starting position. To do this, manually turn the press plate clockwise until it will no longer turn. Then turn it a quarter of a turn counter-clockwise. Now the press plate and the driving screw are in the correct position.

Step 14
Reassemble the body to the grease cup. Hold the body and turn the grease cup clockwise. Turn until it is tight, be careful not to strip the thread.

* Important : The press plate must be flush with the grease cup's piston. Otherwise grease will not be dispensed !
How it works 
¡@